Simple Sturdy Tablet Stand

All the cases with a built in stand were too heavy, so made my own stand! This is designed for pixel tablet (portrait and landscape orientation) but should fit pretty much any 11"ish tablet. Even if you've got a 7" fire, it would fit landscape but not portrait.

Thing is way sturdier than it has any right to be for how light it is (and how little plastic!). Can place tablet on either side for slightly different viewing angles, but if you're doing portrait mode I'd recommend the steeper side. The feet contact spots are also .5" across, which is the size of the most reasonable non-slip feet I could find on amazon. Looking at most of the other tablet options they are insanely tippy, with the "dual sides" on this you actually have to tip it really far before it will actually tip over backwards (more details at bottom).

For printing, nothing special at all. No supports, no nothing. Print two sides, and two supports and you should be good. If you've adjust your flow rate it could mess wit