Thingiverse
Simple Tire with Caster
von ericx
18
Downloads
11
Likes
0
Makes
Simple caster and tire.
Print the wheel, then print the caster.
Will need 3/8 inch metal rod, push on caps from hardware store for axle and caster at the top.
The idea is, take a 3 inch piece of metal rod, glue it in the top, then drill a hole in the object you want to put the wheel/caster on, put 3 inch metal rod in newly drilled hole, then use push caps to hold the caster to the new object. In my case, the caster is being attached to a 2x4 (wood).
Drawn with OpenScad, feel free to play with parameters, not fully paramaterized, but close.
Print the wheel, then print the caster.
Will need 3/8 inch metal rod, push on caps from hardware store for axle and caster at the top.
The idea is, take a 3 inch piece of metal rod, glue it in the top, then drill a hole in the object you want to put the wheel/caster on, put 3 inch metal rod in newly drilled hole, then use push caps to hold the caster to the new object. In my case, the caster is being attached to a 2x4 (wood).
Drawn with OpenScad, feel free to play with parameters, not fully paramaterized, but close.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!