Thingiverse
Simple Toothbrush & Toothpaste Holder
von Huzy85
4
Downloads
4
Likes
0
Makes
Nothing complicated but I needed a toothbrush & toothpaste holder for my 8 months son. A few minutes in thinkercad and this is what I came up with.
The circumference of the toothpaste hole is 34.5mm and 20mm tall
The circumference of the toothbrush hole is 16.5mm and 45mm tall.
Some drain holes placed at the bottom for water to escape.
It can be scaled to your needs.
Printed on an Ender 3 v2 0.2layer height in a marble effect filament with standard settings. Took about 2 hours to print.
The circumference of the toothpaste hole is 34.5mm and 20mm tall
The circumference of the toothbrush hole is 16.5mm and 45mm tall.
Some drain holes placed at the bottom for water to escape.
It can be scaled to your needs.
Printed on an Ender 3 v2 0.2layer height in a marble effect filament with standard settings. Took about 2 hours to print.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
