Simple Under Desk Drawer V2

A rotating gear driven drawer you mount under your desk! Rotating allows you to access or hide the drawer. Easy print in one piece, no assembly required! Small but large enough to hold a couple of pens and other small misc items.

Dimensions: 190mm wide and 1 inch deep.

4mm screw hole is suitable for #6 and #7 wood screw sizes. (Any screw used needs to be ~1.5 inch long to mount). For screws with greater than 4mm thickness, you will have to screw through the print. 7mm thick screws should be fine without causing structural integrity issues.

Recommended minimum wall thickness: 1.2 to 2.4mm

Note: Make sure to install it so that the rear of the body is flush with the edge of the desk.


Credits: Incorporates Emmett's gear bearing https://www.thingiverse.com/thing:53451