Simple universal filament spool holder (customizable)

Part list:
- 2x SKF 608zz bearing (Later I removed the shield. And cleaned the grease OFF. Used some oil. in this way spins way better.)
- 2x OD 8mm aluminium Tube (9mm lenght for me)

Print:
No support needed. (Make sure the countersink hole is upwards)
I inclouded the editable design file as well. If you want it to customize.

Assembly:

- Cut the tube for the desireable size.
- Glue the bearings on to the aluminium tube
- pop the shaft assembly in to the clips
- I was adding countersink M5 thread. You can use it for mounting. Or connect the 2 side and give extra rigidity.