Simple vase with spun facets

I've printed a few of these now, I usually print them stretched to around 250mm high in my rostock delta. The base is purposely wide and the main volume low to make it tip resistant. Experiment with scaling the z axis to get it squat for big bushy flowers or tall and elegant for flowers with more individuality.

Note that this is a solid for "vase printing', so set 1 perimeter, around 3-5 base layers and no top layers. Your nozzle setting should be around double actual to improve adhesion, use 1/4 speed to compensate for the higher pressure required. I find 0.125mm comes out very nicely but you can go up to about half of your nozzle thickness setting for layer height and get a fast print with character.