Thingiverse
Simple VTX Mount - TBS Source One
von wizardofAz
18
Downloads
10
Likes
0
Makes
Couldn't find the mount that I wanted, so I designed my own.
This is still an early iteration, will most likely make updates as I learn more on how it holds up over time.
The hole for the VTX antenna has always been too small in other VTX mounts, which required me to sand the hole into a bigger size. The hole is bigger in this design, so that shouldn't be a problem (you might even have extra wiggleroom).
Print in TPU for best rigidity. PLA works as well, but print a few because they'll likely break on certain crashes.
Print upside down!
This is still an early iteration, will most likely make updates as I learn more on how it holds up over time.
The hole for the VTX antenna has always been too small in other VTX mounts, which required me to sand the hole into a bigger size. The hole is bigger in this design, so that shouldn't be a problem (you might even have extra wiggleroom).
Print in TPU for best rigidity. PLA works as well, but print a few because they'll likely break on certain crashes.
Print upside down!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
