Simple WLED ambience lamp

This is another simple RGB lamp based on RGB-ledstrip WS2812B, ESP32 and WLED, I had at shortened (49 diodes) LED-strip laying around, so I made the lamp height to fit this.When printing the lid, I will suggest to do it on a smooth PEI plate, as it will create the nicest surface. I made a second lamp-base and LED diffusor at 100mm height, then it's possible to cut it down to the desired height in the slicer, just remember that the lamp-base need to be 7,7 mm higher than the desired space for the LED-strip, and the diffusor need to be 4 mm higher. The assembly is pretty straightforward, just solder the wires to the LED-strip and thread them through the holes at the bottom, after winding the LED-strip around the center, then you can either hot-glue the strip end to the center part, or drill holes for a stiff wire to be soldered to the strip and then hooked into the hole(s) like I did (picture 6) There's a ton of good descriptions on the net on how to connect and load the ESP32, d