Simracing Drift DIY hydra e-brake

I slightly redesigned the original ebrake but also added a different spring for me orange/yellow spring Stuyo used was too stiff, so I added a different spring. You can find some on Aliexpress with an outer diameter of 13mm, an inner diameter of 10mm, and a length of 20mm. Also you will need extra hardware than Stuyo used, 2x screw M3 12mm, 1x screw M3 14mm I think, 3x M3 hex nut. Original hardware and instructions you can find here (https://www.diy-sim.com/sim-projects/sim-gear/item/easy-diy-hydro-handbrake#comment-51). Electronics-wise wise I used an Arduino Pro Micro clone from Aliexpress. First of all, after assembly, I uploaded the code to test the hall sensor: void setup() { Serial.begin(9600); pinMode(A3, INPUT);}void loop() { int value = analogRead(A3); Serial.println(value); delay(200);} You need to open the serial monitor with a baud rate of 9600 and look for the minimum and maximum value after pulling the hydro ebrake. When you know your min and max value, you can upload the