Thingiverse
Sinclair QL Power Plug Servo Cable Housing
von PlanC
0
Downloads
0
Likes
0
Makes
Use this together with a male servo cable to make a keyed power connector that will fit the Sinclair QL.
Use a standard 3 wire 'servo cable' ( They are also called HiTec 'S' or Futaba 'J' cables).
Re-order the wires in the connector to match the pinout of the QL and then push the male connector into this housing. You may need to file the inside a little depending on the tolerances of your printer and push pretty hard. Use a cable tie in the hole provided to secure.
You can re-order the wires within the servo connector by using something sharp to lift up the retaining tabs that hold the wires in the connector and slide out the wires to switch them around. I used red for 9VDC, black for Ground and White for 15VAC
This video shows the homebrew power supply I made this power connector for. I have included the Sketchup file if you want to adjust it in any way.
https://youtu.be/3wtGBzwp4DY?feature=shared
Good luck.
Use a standard 3 wire 'servo cable' ( They are also called HiTec 'S' or Futaba 'J' cables).
Re-order the wires in the connector to match the pinout of the QL and then push the male connector into this housing. You may need to file the inside a little depending on the tolerances of your printer and push pretty hard. Use a cable tie in the hole provided to secure.
You can re-order the wires within the servo connector by using something sharp to lift up the retaining tabs that hold the wires in the connector and slide out the wires to switch them around. I used red for 9VDC, black for Ground and White for 15VAC
This video shows the homebrew power supply I made this power connector for. I have included the Sketchup file if you want to adjust it in any way.
https://youtu.be/3wtGBzwp4DY?feature=shared
Good luck.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
