Sinden Lightgun Pump Slider Replacement

This is a faithful reproduction of the pump slider for the Sinden Lightgun, modelled by myself using measurements from the original part for reference.Should your slider break you can replace it easily with this part. The profile includes supports to hold up the bridge section during print, but in some cases you may be able to get away without it as any slight sagging that might occur in such cases doesn't interfere with the mechanism. In some pictures you can see the original part next to the print for reference. Also some pictures show the printed part screwed into the pump grip using the original screws. Although not attached to the main lightgun (as you would not be able to see it, rendering the photo useless!) I hope you never need to use this print, but if you do I hope that you find it helpful.