Single Axis Gimbal Camera Mount for Logitech Webcams

Additional materials to the print:

* 1x SG90 Servo Motor
* 2x M3 Screws, at least 5mm long. Actually the print fits pretty snug to the motor, I've only really used the screws once, so these are quite optional.
* 3x M2 Screws that come with the SG90
* M6 12MM screw to mount the camera to the base.
* About £1.40 in 1p and 5p coins as ballast.
* Some flavour of Pi or an Arduino, etc.

This is a single axis camera gimbal based on the two axis version here: https://www.thingiverse.com/aanarcissus

aanarcissus in turn based his on the fully productized 2-Axis PiHat that's pre-made for giving you pan and tilt functionality, but specifically with Pi-Cams, like this guy:
https://shop.pimoroni.com/products/pan-tilt-hat?variant=33704345034

The biggest problem with putting a gimbal beneath one of the C/B series logitech cameras is that they're heavy compared to the motor and the print, and its hard to center the camera mass above the axis of the motor. I made the camera mount atta