Thingiverse
Single Piece Raspberry Pi Camera Holder
door krissch
3
Downloads
3
Likes
0
Makes
Single Piece Raspberry Pi Camera Holder with an upwards tilt of 15 degrees.
Print on the side with only support in the open lense slit.
You might have some difficulties threading the cable, but try to bend it at the tip to make it go through easier.
Print on the side with only support in the open lense slit.
You might have some difficulties threading the cable, but try to bend it at the tip to make it go through easier.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
