MakerWorld
Other House Models
Go to Model
Sink filter
13
Downloads
1
Likes
8
Makes
This is a filter I'm using in my sink to prevent small bits of food from clogging it. The filter has a diameter of 5 cm and is 11 mm tall. It fits most kitchen sinks—at least, it has in the last two homes I've lived in. I printed it in TPU over two years ago, and it still works perfectly! So I recommend printing it in TPU, but PETG or ABS should work well too. If you plan to use PLA, be careful with boiling water.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
