Thingiverse
Sink Guard
von EvilTeach
2
Downloads
0
Likes
0
Makes
This is an 83 mm diameter guard to put in your sink to stop larger stuff from going down the drain.
It was printed 20% Fill PLA, and covered with 3 coats of spray polyurathane.
It was printed 20% Fill PLA, and covered with 3 coats of spray polyurathane.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!