Thingiverse

Sink Utensil Holder

by hnnnhl

69 Downloads

76 Likes

1 Makes

Utensil holder for doing dishes. There's an incline on the inside so that water doesn't sit at the bottom. Water should flow forward and fall into the sink; although if you test it with a faucet like I did, you might get some flow out of the sides since the side pattern is cut low (but this isn't the typical use case lolz)

Material: PETG

Infill: 15%

Layer Height: .25mm; I set the bottom layers to 6 to make it more dense at the bottom, but probably doesn't make much of a difference.

Supports: No

cutlery Cutlery Drainer cutlery holder diamond Diamonds dishes drainer dry drying rack holder kitchen kitchen sink kitchen tool Kitchen Utensils PETG sink utensil utensil holder utensils

Source

Thingiverse

What you need to print this: Beginner Low confidence

Single piece

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 0/3

Printer

FDM / FFF

File format