Sintech E Key to NVMe Extender

Update: My original design only left 1-2 mm overlap of the adapter. The revision moves the screw hole away by 1 mm adding to the overlap.

This is a printable adapter to use with a LattePanda Alpha and a Sintech E key to NVMe adapter. This piece will extend the length of the E key piece to allow you to screw it down and prevent the board from springing up. You will need to drill out the locating feature for the 2 mm screw that is used for m.2 slots. Take a drill bit that is 2 - 2.5 mm in diameter and lightly push through the plastic. Clean out the hole by holding the drill bit in and spinning the drill bit. Clean off the plastic burrs.

Check out my review here: https://youtu.be/owIFL40NQIs