Thingiverse
Sipeed Maix Bit Case & Lid version 2
by kd8bxp
4
Downloads
4
Likes
0
Makes
This is an updated version of my Sipeed Maix Bit case -
The hole for the lcd is a little small (or at least it printed a little small) - and I used a rotary tool to cut it out a bit - I still need to level my bed better, but since this is a test print, not a big deal.
I ended up cutting the tabs off the bread board to get it to fit easier.
The lid lines up pretty good, could use a little changing, but it works.
Originally I was going to use screws to hold the lid on - but I'm not sure they are needed, it appears to be a snug fit.
I'm hoping someone will improve this.
The hole for the lcd is a little small (or at least it printed a little small) - and I used a rotary tool to cut it out a bit - I still need to level my bed better, but since this is a test print, not a big deal.
I ended up cutting the tabs off the bread board to get it to fit easier.
The lid lines up pretty good, could use a little changing, but it works.
Originally I was going to use screws to hold the lid on - but I'm not sure they are needed, it appears to be a snug fit.
I'm hoping someone will improve this.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
