Thingiverse

sisal scratching post stabilization

by JoeGu

38 Downloads

39 Likes

0 Makes

I wanted to stabilize a scratching post a little bit (preventing it from wobbling).
So I created those stabilization item that can be pushed over the post and fixed with screws to the (bottom/top) plate.

The inner diameter is 108mm (for a post with 90mm diameter wrapped with sisal cord).

Printing it with 1.6-2mm and infill with 20-40% should be strong enough in most cases.

I attached it to a 50cm long post (one to the bottom and one to the top plate) and it works well for me.

cat cat tree cat tube Katze kratzbaum post scratching scratching post sisal sisalstamm stabilization cat cat tree cat tube Katze kratzbaum post scratching scratching post sisal sisalstamm stabilization

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format