Skadis Base Stabilizing Clip

These are additional stabilizers for the base of the Skadis pegboard connected to my AMS V2 riser unit. Files for the connection to the AMS can be found here: https://makerworld.com/en/models/1053825#profileId-1040999 My P1S is sitting on a 16x16 paver block on a piece of foam on the edge of a desk so I needed a way to stabilize the pegboard. These stabilizing feet fit under the lip on the side of the printer and use the concrete block as a depth guide. The vertical thickness may need adjustment depending on how uneven your paver is. You may also need to adjust the distance between the bottom of the printer and the edge of the block (I have approximate 17 mm from the edge of the printer to the edge of the block). I included the .step files if adjustments are needed. I used two of these stabilizers, but you may be able to get away with one positioned near the middle. Installation:If you already installed the Skadis pegboard, the stabilizers will be easier to install without the pegboard