Skadis mounting system

I designed this Skadis mounting system because I cut my skadis board in half because the size I needed wasn't available, and the package only came with one mounting rail. I also didn't like that with a bit of misaligment the board had a seam in the middle, so I designed a part to put between the boards, that forces them into alignment. What you need per board: 2x 4-5×60-80 mm screws for mounting (depends on what you're hanging on your board) 2x 6-8 mm Concrete or drywall anchor (depends on what you're hanging on your board) 2x M3x8-25 for the spacers (the holes can be tight, you have to force these in) Printed parts: 2x Mount Edge Back2x Mount Top2x Spacer Edge Back2x Spacer Top In case you want to connect two boards like i did, you need to add these:2x 4-5×60-80 mm screws for mounting (depends on what you're hanging on your board) 2x 6-8 mm Concrete or drywall anchor (depends on what you're hanging on your board) 2x M3x8-25 for the spacers (the holes can be tight, you have to force th