Skadis Pinecil Mount with Storage

When I finally got a Pinecil I did not like the available options to store the iron on a skadis board with the USB cord I was planning to power it with or additional tip storage. This also incorporates a single 608-2RS bearing allowing you to put the hot iron directly into the mount if you don't have a stand handy. I printed in a polymaker PLA matte and had a little bit of under extrusion but those settings will be dependent on your printing material. I don't recommend adjusting the strength or support settings. Modifications to the actual skadis hooks are already in place to make them more robust. A version without the bearing is available on the second plate.