Skadis Sun

Sun and rays panel with mounting pegs, compatible with Ikea Skadis pegboard. Sun is apx 165 mm x 165 mm, so it should print on an A1 Mini. The sun rays may be separated as objects and printed separately. Pegs:Included are long and short mounting pegs. Long pegs may be used to offset the printed panel from your Skadis, allowing other attachments to still be used. Short pegs hold the printed panel closer to the Skadis, and may not allow other items to be hung from the panel. Due to the variability in Skadis holes, and 3d printing in general, you may wish to print a few extra pegs. Sometimes one (side) will be too tight for either the Skadis or the printed panel. I use pliers to push in and remove the pegs when needed. Using the PEI Hot Plate, and no glue, pegs stick fine to the plate. But you will need a brim and supports on the pegs if using a cold or textured plate. And they print more reliably if you use those anyway, so the print profile includes both enabled. Enjoy,HL