MakerWorld
3D Printer Accessories
Zum Modell
Skadis - wall mount
117
Downloads
37
Likes
50
Makes
Skadis - wall mount Unfortunately, the original mounting is unsatisfactory because the entire surface can't be used.I have remedied this with this model. Simply slide the drilling aid onto the corners - it doesn't matter which way round - the position always remains the same. Then drill through with a 4 mm drill bit. Depending on the size of the screw head, drill a chamfer so that the head is completely countersunk. Then screw it into the desired position using an extension (10mm or 20mm) or a double holder (also 10mm or 20mm) for 2x Skadis – done!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
