Thingiverse
Skateboard Mount
door Damien1997
28
Downloads
32
Likes
0
Makes
Inspired by your local skate shop's board display, I wanted a mount that displayed the bottom of the deck rather than mounting it with the grip tape facing outwards which stops your nasty wheels from marking up the wall.
I wanted something small and durable so they weren't too big and bulky, and was quick to print. These print in around an hour each mount at .4 quality and 150mm/s with any standard printer.
WARNING - PLEASE READ:
You MUST print these flat on the bed and not standing to ensure durability, you MUST use 25% infill, any less may cause failure on the 45 degree corner, I have tested it. These are NOT for snowboards or skiis, Longboards may require 3 due to weight. Make sure to use drywall plugs if you are mounting into direct drywall.
I wanted something small and durable so they weren't too big and bulky, and was quick to print. These print in around an hour each mount at .4 quality and 150mm/s with any standard printer.
WARNING - PLEASE READ:
You MUST print these flat on the bed and not standing to ensure durability, you MUST use 25% infill, any less may cause failure on the 45 degree corner, I have tested it. These are NOT for snowboards or skiis, Longboards may require 3 due to weight. Make sure to use drywall plugs if you are mounting into direct drywall.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
