Skateboard Wall Mount (updated: 3/23)

I did see a good amount on here that i liked, but I wanted one I can quickly print ~1-2 hours and is a simple design.

Instructions:
Honestly easy, print parts with support (skateboard_top.stl is the only one needing support.

- 3 screws total
- if its a heavy board, would recommend some glue between the parts just in case
- theres instructions for this? I guess just look at the picture


only thing is use a good infill. I printed at 25% not thinking about it. Even though it worked out, its not much plastic for the screw to grab in the center.

updates:
- just adjusted the distance between the pegs a little bit.
- noticed netfabb distorted the top. Went back and made it more symmetrical.

1-7-2017 : I reshaped it a little bit for strength and as well as shortening the print time. have it printed around 1.5 hrs.

3-23-2017 : changed the peg sizing and shape a bit, some boards had too snug of a fit