Skeleton 3d Bowden e3d v6 Mount

I saw quite a few pictures of Bowden setups for the Skeleton3d, but I couldn't find an upload for one. So I did what any good community maker would do: I couldn't leave it (the problem) alone.

This is a clamping e3d Bowden nozzle holder for the [Skeleton3d](https://www.thingiverse.com/thing:560353) printer. The halves should clamp using m3 screws and fit into that rectangular nook in the X/Y Carriage. If you're using ABS and the corners curl up a little... that's kind of good! That will help add pretension to the clamping mechanism.

The bottom part needs to be tapped/cut with m3 threading. Or use m3 threaded inserts. If you don't have a tap, then use m3x15 screws and tighten with m3 nuts...
My apologies... I couldn't make nut trap/inserts because it would weaken/thin the structure while causing unnecessary complications for printing without supports.