Skeleton Plarail Track

*Why make this?*
A simple pack of replacement rails to take the place of existing Plarail parts, or connect seamlessly to them.

I live in Canada, where it's rather difficult to get Plarail. Thus, I made these! Nice, quick and easy - much cheaper than importing!

*How to use?*
All the rails should be able to take the place of the equivalent Plarail Track, save for the Auto Y*.
*This track has no equivalent in Plarail, but still fits into the system well. (More information below)

All tracks other than the switches will have to be mirrored, as the tracks are only single-sided. This was to make printing easier by cutting down on the amount of bridging & increasing bed area.

The cutouts in the end of each track are to allow for the J-14 Block Bridge Girder to connect.
(Admittedly, I don't have any girders to check... BUT from what I can tell from images & other models I can find online they should work)

The direction deciders on the switch rails should move freely and smoothly (E.g. wi