Thingiverse

Skeleton Waveguide Subwoofer - (Old version)

par zx82net

121 Téléchargements

115 Likes

0 Makes

![](https://cdn.thingiverse.com/assets/cd/b5/78/fc/82/Thingiverse_banner.jpg)

**Please use the new version here:
https://www.thingiverse.com/thing:5077425 **
==

A remix of Hexibase's subwoofer designed for clear side panels, so the cool waveguide is visible. It would also suit wooden sides. It's smaller than the Hexibase version, so it will print on a 19cm x 19cm print bed. I kept exactly the same tuning as the original by changing the aspect ratio of the port. (The port cross-section, port length, and the chamber volume all match the original.) Frequency response 40Hz - 150Hz.

Fusion 360 Archive and STEP file included for your modding pleasure.

This uses the renowned Tang Band W3 1876S 3" subwoofer driver which is available worldwide (links below). The subwoofer will work with just about any low cost 2.1 channel amplifier or home theatre amplifier, but if you are looking for a DIY amp project with Bluetooth and DSP, check out this one:
https://www.thingiverse.com/

audio bluetooth speaker fusion360 fusion 360 gadget hexibase hifi Loudspeaker speaker subwoofer transmision line audio bluetooth speaker fusion360 fusion 360 gadget hexibase hifi Loudspeaker speaker subwoofer transmision line

Source

Thingiverse

Ce qu'il faut pour imprimer: Débutant Confiance faible

Monobloc

Supports 1/3

Assemblage 0/3

Réglages 1/3

Taille du plateau 0/3

Post-traitement 0/3

Imprimante

FDM / FFF

Format de fichier