Skewer Pushrod Fitting V2

###################### NEW Version 2 ######################

1. Fittings are 50% small1er reducing fillement used, and improving the over all look of the push rods.
2. The sections of 16 gauge wire used for the connection to control arms and horns has been reduced.
3. No more Z bends. The adapter now has a built in keaper arm that allows the use of a simple 90deg bend in the wire, while making installation and removal easier.

###########################################################

Parts [Makes 1 push rod]:
A. 2 skewer pushrod fittings.
B. one bamboo skewer around 3.1mm - 3.2mm dia.
C. About 60mm of 16 gauge wire.
D. Glue. Use CA glue, I am specifically using Gorrilla super glue, and having excellent results with pla. I had some issues with a few other name brands while testing. Note: Hot glue did work well in testing as long as the parts were a snug fit to begin with. Use with caution.

To assemble:

1. Bend about 3mm at the end of the wire 90 degrees.
2. Cut the