SKGO Bed frame stabilizer

A subtle remix of Pretorrien's original excellent design to beef up and stabilise the two screw/rail bed of the Seckit SKGO 3D Printer. In this version, all I did was open up the cross-shaped cut-out at the bottom to better clear the leadscrew brass nut fixing screws. I found the original just a bit too tight for my application.

I printed these in solid ABS on a Stratasys printer. Definitely overkill. Pretty sure PLA with 30-50% infill would be adequate as long as it's not going to be exposed to Temps over 50C.