Skinny TUSH++

The original 3mm walls of the TUSH (The Ultimate Spool Holder) were way too thick to fit inside of the generic cereal boxes I had while using a 68mm wide Bambu spool.The walls in this remix are 1.4mm, with added reinforcement along the bottom to keep it strong despite the thin walls.It's compatible with TUSH++ rails. Since the walls are thinner, it wobbles a little bit on the rails. If this is a problem, the wedges can be used for extra support.InstructionsAll items can be printed without supports.I used a 0.4mm nozzle with 0.2mm layer height on a Bambu P1S.Assemble using 4x 608 ball bearings that snap into the pegs.The .f3d file is included if you need to change the thickness or if the bearing pegs need to be modified for your printer.