Thingiverse
Skipping rope
by kiam02
1
Downloads
6
Likes
0
Makes
Handles for skipping rope
The ball bearings on the handles of the skipping rope were rusty. Doubbel unders are no longer suitable for fast rope jumping. The 2.5mm thick rope can still be used. So decided to construckt a handle with a bearing for my skipping rope. A few tries to print out and the skipping rope was ready. I use it for my favorite sport Crossfit, it has proven to be very effective. The skipping rope consists of two parts. Both parts are placed in the middle of the printing surface. Different layer heights can be used. Layer height 0.3 for Handle and 0.15 for bearing. So the Handle is easier to grippier and the bearing is smooth. The skipping rope can be threaded in the upper two holes.
Happy printing jumping
The ball bearings on the handles of the skipping rope were rusty. Doubbel unders are no longer suitable for fast rope jumping. The 2.5mm thick rope can still be used. So decided to construckt a handle with a bearing for my skipping rope. A few tries to print out and the skipping rope was ready. I use it for my favorite sport Crossfit, it has proven to be very effective. The skipping rope consists of two parts. Both parts are placed in the middle of the printing surface. Different layer heights can be used. Layer height 0.3 for Handle and 0.15 for bearing. So the Handle is easier to grippier and the bearing is smooth. The skipping rope can be threaded in the upper two holes.
Happy printing jumping
kiam02 also publishes on
41 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!