Thingiverse
SKS Stripper Clip Pouch
von ryandetous
50
Downloads
44
Likes
0
Makes
This is version 1 of a belt mounted stripper keeper for the SKS. The belt loops and latches should be printed on their sides. The main body should be printed open side up. The latches are a bit tight, so good luck. A test print of the pouch was done at .2mm so higher resolution should be fine. Use tree supports on the few overhangs and 2+ walls.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
