Thingiverse
Skull earring
von goldfishlaser
88
Downloads
55
Likes
1
Makes
My recommendation is to print two and carefully glue them together. This allows both sides to have the details. Then add jump ring to add to earring.
When assembled, earring is large at 3 mm thick, ~45 x 60 mm
Takes about 30 minutes to print
When assembled, earring is large at 3 mm thick, ~45 x 60 mm
Takes about 30 minutes to print
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!