Skull hat & cap holder Extension

When making the Skull hat & cap holder by TV1889 I noticed that you had to bend your hat slightly up in the back to fit it on there where the hat would not cover the face of the skull. After some quick design and a couple of prints I found this to work. For strength purposes lay it it down on its side so that the lines while printing are long ways. I have found that if you stand it up it prints easier but with vibrations from the door shutting and with kids slamming the doors it will eventually snap and your piece will fall. Thanks for all who download this. Please Check out TV1889's Skull at: https://makerworld.com/en/models/1041755-skull-hat-cap-holder?from=search#profileId-1026794