Thingiverse
Skull Lampshade
von baobibis
45
Downloads
43
Likes
0
Makes
A spooky lampshade based on hangar series lamps. Low poly version included.
See my other models at CGTrader:
https://www.cgtrader.com/baobibis
Donate through Paypal:
https://www.paypal.com/donate/?hosted_button_id=YPUX7LAYESXJN
Fits E27 bulb holders. Standard 45mm center hole diameter should fit most fixtures. Make sure to only use LED bulbs with 3D printed lamps!
Test print done out of PLA with 0.6mm nozzle at 0.2mm layer height, however due to simplicity of the model other materials and settings will also work. Print upside down, bulb holder side at the buildplate with no supports.
See my other models at CGTrader:
https://www.cgtrader.com/baobibis
Donate through Paypal:
https://www.paypal.com/donate/?hosted_button_id=YPUX7LAYESXJN
Fits E27 bulb holders. Standard 45mm center hole diameter should fit most fixtures. Make sure to only use LED bulbs with 3D printed lamps!
Test print done out of PLA with 0.6mm nozzle at 0.2mm layer height, however due to simplicity of the model other materials and settings will also work. Print upside down, bulb holder side at the buildplate with no supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!