Thingiverse

Skulltruder

von schlem

523 Downloads

426 Likes

24 Makes

Behold and fear my Skulltruder! This is a set of spur gears for the Printrbot or any printer using Wade's accessible extruder. 13:43.
Reworked from Brook Drumm's Printrbot's involute herringbone gears, (which were ultimately derived from works by Wade and Frost) http://www.thingiverse.com/thing:16990 and Cleaned Skull by ssd (http://www.thingiverse.com/thing:4126 .
Watch one come to life:
http://www.youtube.com/watch?v=VFnkdYUqQWs

New 4mm drive gear!

___
**ATTENTION**
This work is licensed under the [Creative Commons - Attribution - Non-Commercial license](http://creativecommons.org/licenses/by-nc/3.0/). This license applies only to the files and documents available for download from the **Thing Files** section of this Thing.
**All other related content (photographs, videos, and verbiage such as contained in "Description" or "Instructions" ) are excluded from this license. with all rights reserved, unless specifically available for download** This notice constitu

bevel gears extruder involute PB plus printerbot printrbot printrbot plus schlab schlaboratory schlem skull Wades bevel gears extruder involute PB plus printerbot printrbot printrbot plus schlab schlaboratory schlem skull Wades

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat