Thingiverse
skywatcher 150 dew shield
von JuliusStanionis
5
Downloads
0
Likes
0
Makes
Dew shield for skywwatcher 150 telescope. Printed parts only, no other materials needed. However white part at the end of telescope where dew shield fixes is quite slipper, so i recommend applying some electrical tape.
Print in the darkest PLA you can get your hand on :) .
Print in the darkest PLA you can get your hand on :) .
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
