Thingiverse
Slashlight Stand 2.0
von Zom-B
0
Downloads
4
Likes
0
Makes
A modern, strong, tall flashlight stand. I thought about posting it as a remix to "Stand for Mini LED Flashlight by Smidge204" but I realized I changed so much it might as well be a new thing. Oh, I can't uncheck the Remix checkbox, and I'm too far into detailing it for me to start over. Oh well...
Design tips:
- Under-size the flashlight diameter by 0.5mm to prevent it simply sliding out.
- Keep the base thin and flexible enough so you can wedge the pillars apart to fit the hinge axle. The hinge cannot be inserted from the top.
- The pillars probably don't need much infill, or any at all. The base, however, does!
- Thicker arm thickness means thicker hinge axle means more friction.
- I might try with increased hinge_length the next time, for even more friction. This is the length of the axle on either side.
Design tips:
- Under-size the flashlight diameter by 0.5mm to prevent it simply sliding out.
- Keep the base thin and flexible enough so you can wedge the pillars apart to fit the hinge axle. The hinge cannot be inserted from the top.
- The pillars probably don't need much infill, or any at all. The base, however, does!
- Thicker arm thickness means thicker hinge axle means more friction.
- I might try with increased hinge_length the next time, for even more friction. This is the length of the axle on either side.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!