Thingiverse
Slay the Spire Watcher
por warmarine759
36
Descargas
24
Likes
0
Makes
This model is somewhat difficult to print due to the low surface area + high supports
I printed the body with a raft + support bottom layers + support angles 0/45% and Z hop
The ribbons and staff shouldnt be too much trouble though
The staff hole might need a little enlarging it seemed a little snug but it was easy enough with a soldering iron. I used a heat gun to slightly soften her hand to a curl it around the staff a bit more.
I printed the body with a raft + support bottom layers + support angles 0/45% and Z hop
The ribbons and staff shouldnt be too much trouble though
The staff hole might need a little enlarging it seemed a little snug but it was easy enough with a soldering iron. I used a heat gun to slightly soften her hand to a curl it around the staff a bit more.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
