SlayBlade

My first try in creating a fully 3D printable BayBlade-like toy with its dispencer. Im planning on optimizing its looks and performance but for now Im publishing my first version.
Most parts can be printed without using supports (for fdm printers). The connecting pins for the handle are designed with the toleracnes of my 3D printer in mind but if they turn out too loose for you, you can just use glue to secure them. Supports will be needed for the actual spinning top as it is designed to be printed in an upright position. Also the SpinnerMechanism is designed to be printed upside down (with the gear flat on the bed) and therefore needs two very small supports, one on each connecting tooth, that can be cut after the print with some cutters without paying too much attention on the surface finish as it is allowed by the tolerances of the fit.