Thingiverse
Sledgefire Flare strip
von Ruslan_Mystwing
13
Downloads
1
Likes
0
Makes
I borrowed Cramplehade's measurements (also didn't wanna recreate the sledgefire shell shape when it was available.) and since blender's a bit iffy on scaling. i don't wanna bother with scaling.
Print at horizontal expansion -0.8mm, that's what I did. Little tight initially but after sliding them in and out a couple times it'll work great, does help condense a loadout down and doesn't get in the way as it just hangs.
Print at horizontal expansion -0.8mm, that's what I did. Little tight initially but after sliding them in and out a couple times it'll work great, does help condense a loadout down and doesn't get in the way as it just hangs.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!