Sleek Ender 3 LED Light Bar

# Introduction
I designed this to light up the printer area, so i don't have to turn on the room lights to take out my freshly printed parts :P
I wanted a design that has an LED difuser, and what a great idea to print one!
Any white PLA should do the trick, as the difuser is only one layer wide.

Be advised, this LED bar might interfere with the extruder cable's movement when it is in the upmost Z position.
# What you will need
## Printed parts
- **1 x support_clip_middle**
- **1 x support_clip_end_right**
- **1 x support_clip_end_left**
> *For these 3, make sure to have a good amount of top and bottom layers to prevent light leaking from the sides!*
- **2 x ledcover**
> *This one is a tricky part to print, it must be upright, have a solid adhesion, and make sure to set horizontal expansion to 0.1mm in your slicer settings, to enhance the printing quality.*
- **1 x backpiece_left**
- **1 x backpiece_right**
> *These two parts must be either solid, or have a goo