Thingiverse
Sleeve for 3D/BL Touch Sensor
door xrxca
24
Downloads
18
Likes
1
Makes
Sleeve to protect a 3D or BL Touch Sensor, and cover the LED
After my Touch sensor crashed into a part that came off the build plate, I wanted a shield for it. I also wanted to cover the LED as it was overly bright in my captures.
I designed it from scratch in OpenSCAD to go over the sensor from the bottom, so the probe is protected unless deployed, and it replaces any nuts used for mounting the sensor, just 3mm bolts into the sleeve (I tapped the holes, but you should be able to put bolts in without tapping (do so before trying to mount in place).
It's fairly tight to the sensor but may require adjusting of the mount used so the sleeve clears other parts.
After my Touch sensor crashed into a part that came off the build plate, I wanted a shield for it. I also wanted to cover the LED as it was overly bright in my captures.
I designed it from scratch in OpenSCAD to go over the sensor from the bottom, so the probe is protected unless deployed, and it replaces any nuts used for mounting the sensor, just 3mm bolts into the sleeve (I tapped the holes, but you should be able to put bolts in without tapping (do so before trying to mount in place).
It's fairly tight to the sensor but may require adjusting of the mount used so the sleeve clears other parts.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
