Thingiverse
Sleeve support
von Mzhang
0
Downloads
0
Likes
0
Makes
Suddenly found that they have a lot of sleeves, from 4mm-13mm, a total of 11, and 2 hexagonal connecting rods, so I designed this bracket.
This bracket makes it easy to place these sleeves and connecting rods.
The outer diameter of the sleeve is:
12mm, 6;
13/14/16/16/17, one for each of the five above.
Welcome to print and use.
This bracket makes it easy to place these sleeves and connecting rods.
The outer diameter of the sleeve is:
12mm, 6;
13/14/16/16/17, one for each of the five above.
Welcome to print and use.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!