Thingiverse
slider for QQS
door johnroy22222
5
Downloads
1
Likes
0
Makes
Work in progress because i need to improve the design (it should be upside down).
I ve installed this one on my QQS. It works ok.
But i have to redesign it upside down. The belt linkage should be on the right when watched from the back of the vertical rods.
I ve printed it with 100% infill.
It needs to be an accurate print for obvious reasons. Check the accuracy of your printer (there is a software on facebook, with a funny 42x42mm rabbit)
I ve attached the stock design from FLSUN. They just sent it to me.Can always be useful.
I ve installed this one on my QQS. It works ok.
But i have to redesign it upside down. The belt linkage should be on the right when watched from the back of the vertical rods.
I ve printed it with 100% infill.
It needs to be an accurate print for obvious reasons. Check the accuracy of your printer (there is a software on facebook, with a funny 42x42mm rabbit)
I ve attached the stock design from FLSUN. They just sent it to me.Can always be useful.
johnroy22222 publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
