MakerWorld
Other Hobby & DIY
Go to Model
Slider Pod
126
Downloads
30
Likes
72
Makes
This is a low-level ground tripod. This print will require a 3/8-16 by 1 inch cap head screw and a matching threaded nut. I also suggest using supports for the filleted sides as they are generic fillets and will print a little poorly without support. Bill of Materials1 x 3/8-16 by 1" cap head screw for the gimbal head mount (inserted from the bottom)1 x 3/8-16 nut to secure the cap head screw (from the top)
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
