Thingiverse
Sliding Door Lock
by LilJacket
73
Downloads
73
Likes
0
Makes
Very convenient little sliding door lock! Perfect for chicken pen doors, dog pens, or to finally keep that door in place to protect your valuable crops from any wildlife (or your dog, speaking from experience).
The sliding lock consists of 4 parts:
- the door piece (big piece)
- the pole piece (smaller piece)
- slider
- slider knob
You are fully free to choose whether you want the door piece with or without my logo :)
Together with these 4 parts, you will need 6 screws which can fit in the 5 mm diameter holes, any screw should work.
I recommend printing this part in ABS, since it is more resilient against various weather types. The version shown in the thumbnail picture was printed in PLA and has been holding up well for a couple of weeks, although I have to note that the weather conditions are rather soft in my area (not too warm, cold or rainy).
If the slider knob and slider do not fit nicely together for some reason, a little hammering and super glue never fails
The sliding lock consists of 4 parts:
- the door piece (big piece)
- the pole piece (smaller piece)
- slider
- slider knob
You are fully free to choose whether you want the door piece with or without my logo :)
Together with these 4 parts, you will need 6 screws which can fit in the 5 mm diameter holes, any screw should work.
I recommend printing this part in ABS, since it is more resilient against various weather types. The version shown in the thumbnail picture was printed in PLA and has been holding up well for a couple of weeks, although I have to note that the weather conditions are rather soft in my area (not too warm, cold or rainy).
If the slider knob and slider do not fit nicely together for some reason, a little hammering and super glue never fails
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
