Thingiverse
Sliding door stopper
por hclxing
28
Descargas
22
Likes
0
Makes
This is a sliding door stopper. Part_A is the hindge, it's a inplace printed ball joint, so make sure you print it with the cylinder upward with support in the bottom hole.
The rod is a PVC pipe, measured at 20.5mm ID and 26.8 mm OD (not sure what standard pipe dimension that is)
The rod is a PVC pipe, measured at 20.5mm ID and 26.8 mm OD (not sure what standard pipe dimension that is)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!